Heat Pump Repair in Tillamook, OR
If your system quits, tell us what it's doing and a licensed contractor who covers Tillamook County will get in touch.
Tell us about the job
It takes about a minute.
Ten months of heat pump use a year in Tillamook County
Your heat pump runs September through June here. Winter nights average 35°F, mild enough that the heat pump does the job alone most days without backup heat kicking in. That means the compressor and reversing valve are cycling on and off almost all year, not just a few winter months.
Almost 8 in 10 homes here heat with electricity, and this county has seen 6 damaging wind events over the past ten years. When the power drops, a heat pump can come back confused or not at all if the outage cuts power mid-cycle. If yours won't turn on after the lights come back, check the thermostat and breaker before assuming the unit itself failed.
- 10 months
- September through June, your system heats
- 35°F
- the average winter night it heats against
- 70°F
- the average summer afternoon it cools against
Oregon requires HVAC contractors to hold a state license.
The Construction Contractors Board tests and records the contractor, not the job. That license is tied to the business doing the work, and it stays in place across every job that contractor takes on in this state.
A heat pump repair almost always means opening the refrigerant side of the system, and that requires EPA Section 608 certification no matter which state you're in. In Oregon, if the repair runs under $1,000, the state does not require a licensed contractor for that job.
Source: Oregon Legislative Assembly
- Why is my heat pump blowing cold air?
- In heating mode, air from the vents is naturally cooler than your skin, so it can feel cold even when the system is working right. If it's blowing air that's actually cold, not just cool, check that the outdoor unit is running and isn't caked in ice. A refrigerant leak or a failing reversing valve can also stop the system from producing heat, and both need a licensed contractor since only someone with EPA 608 certification can open the refrigerant side.
- Why is there ice on my heat pump?
- A thin layer of frost on the outdoor unit during cold weather is normal, and the system defrosts itself on a cycle. Heavy ice that doesn't clear points to a problem, often a dirty coil, a low refrigerant charge, or a defrost control that isn't switching the unit into defrost mode. With winter nights here averaging 35°F, the unit is defrosting often through the cold months, so a defrost board that's failed will show up fast as ice buildup. Don't chip the ice off yourself. A contractor can find out why the defrost cycle isn't clearing it.
- Why is my heat pump running but not cooling?
- If the outdoor fan and compressor are running but the air coming out isn't cool, the most common causes are a dirty air filter restricting airflow, a coil covered in dirt, or a refrigerant leak. A leak means the system has less refrigerant than it needs to move heat properly, and fixing it requires a technician certified under EPA Section 608 to handle the refrigerant side. Summer afternoons here only average 70°F, so cooling problems are less urgent than a heating failure in winter, but the cause is worth finding before the system has to work harder in warmer weather.