HVAC Repair in Brookings, OR
If your system quits, tell us what it's doing and a licensed contractor who covers Curry County will get in touch.
Tell us about the job
It takes about a minute.
Nine months of heat, and not much cooling to speak of
Your furnace in Brookings runs from October through June. That is nine months of the year, most of it on nights that average 37°F. A furnace built to cycle on and off through a real winter still wears with that much use, and the igniter and the blower motor are usually the first to show it. When one of them gives out, you notice fast because there is no mild stretch to ride out until you get to it.
Summer here barely asks anything of a cooling system, with afternoons averaging 76°F. But storms are a different story. Curry County has seen 47 winter storms and 185 damaging wind events over the past ten years, and close to 20% of Oregon households lost power for a full day or more in 2024. Most electric furnaces and heat pumps come back on by themselves once power returns, but a hard outage during a cold snap can still leave a house cold long enough to matter, and it is worth knowing whether yours is one of the ones that needs a hand restarting.
- 9 months
- October through June, your system heats
- 37°F
- the average winter night it heats against
- 76°F
- the average summer afternoon it cools against
Oregon requires HVAC contractors to hold a state license.
The license is held by the contractor, not issued job by job, so the Construction Contractors Board has tested and recorded that business before it ever gets to your address in Curry County. If the repair runs under $1,000, Oregon does not require a licensed contractor for it. Above that, it does.
For a repair on a heating and cooling system, that license is what stands behind the work. It tells you the state has tested this contractor and keeps a record of them, not just this one job. The thousand dollar line is the one exception Oregon draws around that rule.
Source: Oregon Legislative Assembly
- Why is my heat not working?
- Most of the time it comes down to power, gas, or airflow. If your furnace runs on electricity, check the breaker first, since a tripped one is the simplest explanation. If it lights but the burners never catch, the igniter or flame sensor is likely worn out and needs replacing. A clogged filter can also starve the system of airflow until it shuts itself down to protect the heat exchanger. Heat is needed here nine months of the year, so it's worth having a contractor look at the system before the next cold stretch rather than after it fails again.
- Why is my system running but not cooling the house?
- If the blower runs but the air coming out isn't cold, the problem is usually with the refrigerant side, not the fan. A dirty coil, a low refrigerant charge, or a failing compressor can all leave you with air movement and no cooling. Check the filter first, since a blocked one restricts airflow across the coil and can ice it over. If the coil is frozen, turn the system off and let it thaw before a contractor looks at it, since running it iced up can damage the compressor.
- What can I check before calling for HVAC repair?
- Start with the filter. A dirty one restricts airflow and can cause problems that look like bigger failures. Check the thermostat batteries and settings, and make sure the breaker for the system hasn't tripped. If you have a gas furnace, confirm the gas valve is open and the pilot or igniter is doing what it should. If the outdoor unit is involved, clear away any leaves or debris blocking it. Beyond that, diagnosing what's wrong inside the system is a job for a licensed contractor, who can price the repair once they've seen the house.